Newer Than: Search this thread only Search this forum only Display results as threads More... DD-WRT routers are great for this, but as we discovered when reviewing the budget Linksys N300, the modest processors found in low cost routers can struggle with the demands of handling A router can only talk to one device at a time. If you can not reach your dd-wrt router using the IP address assigned by the DHCP router (as reported in the DHCP tables thereon), then your dd-wrt router should be reachable my review here
I'm now considering taking advantage of the VPN options that are offered. #4 MusicMax, Nov 12, 2012 JackMDS Super Moderator
Elite Member Super Moderator Joined: Oct 25, 1999 Messages: 27,853 Likes I turned off dhcp on router #2 so the connectivity between the two routers doesn't seem to work properly. Other instructions on the web seem much more complicated and also required the creation of a Virtual AP. ESSID) on the other (virtual) interface or do not use any encryption on the virtual interface at all. http://www.dd-wrt.com/wiki/index.php/Repeater_Bridge
Stay logged in Sign up now! Heh heh. I thought setting it up as a repeating bridge would work but if I turn off wireless on the primary router there isn't any wifi to be found.
You can fill in the primary SSID simply by typing it in on the secondary router instead of using site survey to type it for you. Thank you so much for taking the time to document these steps and help others! Back to top SandmanCLDD-WRT NoviceJoined: 06 Oct 2009Posts: 8 Posted: Thu Oct 08, 2009 8:21 Post subject: It's with sort of a bitter sweet joy that I can report that Dd Wrt Bridge Mode It's not that big of a deal, and not that complicated.
EX: host using WPA2 Personal AES will still work if the repeater is set to WPA2 Personal Mixed AES, for whatever reason, as it includes the algorithm in use (WPA2-AES) Click Dd Wrt Repeater Bridge Drops Connection This isn't the problem though. Petofi95Jun 19, 2015, 12:39 AM Eventually your words helped me! Thanks a lot!
Click Save Click Apply The router should immediately connect and both extend the wireless range but also the LAN ports work and Internet should work See also: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=153372  Qualcomm Atheros Client Bridge Dd Wrt Doesn't DD-WRT have an explicit repeater mode? Ping test(?) the DDWRT router and the Main router to see the response times, I'm curious because I already know I get horrible and slow WiFi connections in the room the I have a secondary router that I want to service my wireless clients upstairs.
Perhaps upping it now to an hour and walking away (from the house) they will work:-) logically. All Rights Reserved Theme designed by Audentio Design. Dd Wrt Wired Repeater Back to top HyeVltg3DD-WRT NoviceJoined: 16 Jun 2013Posts: 6 Posted: Thu Feb 27, 2014 4:45 Post subject: notorious.dds wrote: Just an idea about the lags... Dd Wrt Wireless Ap twitterfacebookgoogle+LinkedInEmail As you are reading this article on BestVPN, then it is likely you originally bought a DD-DRT router so you could connect all your internet enabled household or office devices
Qualcomm Atheros units have it simple, & trying to follow most other things outside of this QCA section will result in problems. this page Choose Repeater Bridge under wireless mode. Put a piece of tape over the WAN port of your dd-wrt router--you don't want to use it by mistake. They will receive IP Addresses from the Primary Router and will be able to use the Internet connection supplied by the Primary Router. Connect Dd Wrt To Another Router
Also note that during setup you should not click ‘Apply Changes’ until setup is complete. 1. Best regards A. Use a wireless bridge to transparently connect computers in one room to computers in a different room when you cannot—or don't want to—run an Ethernet cable between the two rooms. http://haiteq.com/dd-wrt/dd-wrt-repeater-bridge-wireless-not-working.php My question is the following : what wireless mode should I use for the two dd-wrt routers : AP, Client Bridge or Repeater Bridge?
It will be up to the user to set up security between the Primary and Secondary routers Note: If you are unsure of what you are doing, it is advisable to Dd Wrt Repeater Vs Repeater Bridge Reading through the steps it sounded promising because the others always failed with the virtual adapter and this option didn't have that. Hung Reply Douglas Crawford VERIFIED says: March 20, 2015 at 9:49 am Hi A.
I am running DD-Wrt as well on one router and it works great as a repeater. I was glad to find these instructions since it is by far the easiest, however its not working for me. 🙁 Maybe something to do with the WDS option. Special thanks to Griminal for providing a basic graphic which I modified for this Wiki Entry. Dd Wrt Client Bridge Mode That has nothing to do with your issue but it may cause some disturbance on the connections if the routers are close together, using the auto setting is usually best!
I'm afraid that I no longer have this setup running, so can't run any tests. Here are the steps: Unplug all ethernet ports from your dd-wrt router. The router will restart in order to apply all the settings, and you will find your WiFi signal greatly improved as you move around your house or office! useful reference However, is there anyway to determine when you are accessing the repeater or accessing the main router?
johnnypoozerJun 14, 2012, 11:07 PM ngrego said: No Prob, and thanks for the screen shots.Could you please post me a screen shot of the DHCP Setup on the Dlink and the If I were you I would give it a try. solved Set up a ubuntu home server without internet connection.