Home > Not Working > Car Keys Remote Not Working

Car Keys Remote Not Working

Contents

Now the vehicle will start but after 4-5 mins (i have times it) When pressing start it acknowledges with the one beep and the dome light comes on, then 4-5 minutes A little red LED on the fob should flash when you push any of the fob buttons. Helpp i dont know whats wrong!! Please try again later. http://haiteq.com/not-working/computer-keys-not-working.php

This time, to help the metallic tape 'dots' stay in place better I thoroughly cleaned the rubber-vinyl insert to the fob that the tape dots adhere to. Peter Finn 151,703 views 11:04 Car Key fob button repair - Duration: 6:53. Your best bet is take it back to your installer and have them take a look at it. I live in Ravena, NY if you happen to know of anyone who may be able to help. http://www.ebay.com/gds/Top-5-Tips-in-Fixing-a-Keyless-Remote-/10000000178627254/g.html

Car Remote Lock Not Working

Premium memberships & other ways to support PriusChat will be available very soon. Here is the "BUT"…. Use the camera on your cellphone to capture and save the size, type and placement, for easy recall. hi, i am having problems with my car remote key it is not doing anything..

Reply CJ says November 9, 2012 at 4:11 pm My remote starter started my car today, within a few minutes-after I pressed the unlock button to get in- the car just It worked fine for a year, and now this happens……any suggestions as to taking it to the installer (because the remote starter may need to be adjusted) or taking it to Thanks!

I just fixed my fobs by gluing tin foil to the rubber piece. Key Fob Problems You have to take out the metal key & use it to unlock the driver's door?

This may sound like the door ajar signal. Reply Randy says January 18, 2013 at 5:12 pm Have a 2004 Chevrolet Silverado with a nustart 1500 installed in it, worked fine up until last week lock and unlock buttons Why can't the factory key fobs be used to open the doors. Reply Mitch says December 6, 2012 at 7:15 pm Hard to diagnose without seeing it but I would start by checking the tach sensing wire.

I had a cheapie soldering iron and, with a magnifier and needle nose pliers,'was able to re-solder it. Car Key Not Working In Ignition On the Prius, the alarm sounded as soon as I got in the car (having opened the car with the manual metal key). I entered the passive mode UNLOCK+TRUNK UNLOCK, and the remote eas working normally.I have a 2011 Ford F-150. They may or may not charge for this service.

Keyless Entry Remote Not Working

Remember not to add too much solder; large globs could short out connections on these tiny circuit boards. This just happened to my remote start this weekend… Car starts fine manually but won't start by remote, like it's not cranking long enough… Any ideas or suggestions are welcomed to Car Remote Lock Not Working Ken V, May 15, 2009 Taimur Nizami likes this. Car Remote Stopped Working Usually it's is the other way around and it's a simple matter of taking the device out of valet mode.

We have not had any service done on the car. this contact form This is if the Car is still under warranty. Chevrolet HHR - Maintenance & Repair DASH LIGHT THAT SHOWS CAR WITH A LOCK ON IT 13 answers THIS LIGHT SHOWED UP AFTER SERVICE TO PROG A REMOTE ENTRY Chevrolet HHR The dash lights, radio and heater stay on like the key was in the dash but the car does not stay running. Car Remote Not Working After Battery Change

Reply 1 Linda Buchtel 6 months ago Found this info great, I took mine apart because only the open button wasn't working. I've read the manual and it says related to Engine On. bunnybr 252,705 views 6:53 Fixing A Broken Car Remote - Duration: 2:28. have a peek here Symptoms: Lock and Unlock buttons work as normal, but pressing Start does not produce any response from the vehicle.

Reply Mitch says January 26, 2012 at 10:32 pm My guess would be that it is a Passlock issue on that vehicle.. Key Fob Wont Work After Replacing Battery Loading... All I can say it just stopped working for some reason.

P:s.

You should take it back to your installer and have them check it out… That is a tough one to diagnose without seeing it.. it is labelled "key" right? I thought of it only as a lubricant for cable-driven devices such as old school speedometer cables. Car Remote Doesn't Work If equipped, Lock and Unlock still function.

But after my first stop when I tried to... 2011 Chevrolet Malibu LT - Maintenance & Repair Looking for a Used HHR in your area? my key is not a transponder, just plain old key. SOLUTION, fix: Transmission & Received wireless reliability, depends on the outside ANTENNA CONNECTION. http://haiteq.com/not-working/car-keys-fobs-not-working.php I spoke with the installers (over the phone) and they did not tell me your great 1/2 second rule.

Sign in to add this video to a playlist. Double check all of your wiring and connections. They started the car remotely right after i changed the battery, but now the remote starter is no longer starting the car. olaf2046 136,544 views 6:02 Auto Locksmith Tool Car Key Programmer CK-100 CK100 V39.02 SBB by OBDChina - Duration: 6:44.

Reply Mitch says February 14, 2012 at 11:08 pm "patting myself on the back!:)" Seriously though…. Other times, you will have to return to the store for a technician to program it. Anyway, when I got the car the remote start worked one time then months later I went to use the remote start and it won't work. Reply 1 Steve Holte 10 months ago - edited 10 months ago Thanks for posting this.

Most of our remote starters go into valet mode by pressing a combination of two buttons on the remote control for 1/2 second.

>