Home > Not Working > Caravan Flashers Tail Lights Not Working

Caravan Flashers Tail Lights Not Working

Contents

Thanks Reply rwtrailerparts says: January 18, 2016 at 7:43 pm Trailers in the US are wired so that the turn/brake lights are the same function. The SCM reads the resistor multiplexed input from the multi-function switch and sends an electronic turn signal switch status message over the LIN data bus to the EMIC, which relays an Reply Mezza says: December 18, 2015 at 5:59 pm Hi Picked up my trailer today which has been fitted with new LED's. td.10-12-2011, 02:02 PMSo you know it's not the bulb. have a peek here

Please can you help. I have running lights on both but turn signals only blink on the running light part of the bulb I have the ground drilled through the trailer and bolted tight. Thanks.From memory, I don't think that the bulbs are coloured and I cannot remember if they are screw in or the bayonent type. If a rapidly flashing turn signal is observed, a light is burned out or there is loose or open connection to a light. http://www.practicalcaravan.com/forum/technical/40612-caravan-electrical-problem

Caravan Road Lights Not Working

razorreilly0910-12-2011, 01:12 PMblinking quickly may be a relay issue Flash10-12-2011, 01:25 PMblinking quickly may be a relay issue We also have no back up lights on passenger side. Thank you! The wiring should be as follows:1 Yellow - left indicator2 Blue - Caravan fog light3 White - Earth4 Green - Right indicator5 Brown - Right hand tail light6 Red - Stop Do you have the same problem?YesNo Wednesday, June 13th, 2012 AT 1:55 AM 12 Replies saturntech9 Expert 30,134 posts So the running lights are inop front and rear?Also you have power

Should be able to just pull the release lever, and it should come right back up..... Nearside Caravan Lights I have no nearside lights at all that come on in my caravan. A tail light wire could have been crushed behind the housing during installation, but the inevitable short may not surface for long periods of time, perhaps when moisture gets behind the Inspect all bulbs and replace as needed, then recheck the system.

Repacking Trailer WheelBearings → 43 Responses to Diagnosing and Repairing Trailer Lights andWiring Jason says: December 15, 2011 at 12:19 am A lot of great content.. Caravan Interior Lights Not Working Turn on running lights and a turn signal and test by putting your stick tester to the terminals. Reply rwtrailerparts says: August 26, 2016 at 5:44 pm The bulb is blown on the truck, or the trailer? https://www.2carpros.com/questions/2002-dodge-caravan-tail-lights rwtrailerparts says: June 21, 2016 at 5:52 pm Then I would remove each light (tail and marker) one at a time and check for a crushed wire.

Answer Questions Where is the thermostat on 2000 dodge intrepid? Code ladder, Robbers I don't want to do research (First year tenure-track faculty) Teenage daughter refusing to go to school Why did they look stupid? Is buying a Dodge Ram truck with 275,000 miles for $3000 worth it? There is a Combination turn signal/hazard flasher/Daytime Running Light module that is mounted under the dash at Junction block.

Caravan Interior Lights Not Working

Take a look in the fuse boxes under the hood, probably wont find anything but worth a look. It only dented the bumper did not hit the lights. Caravan Road Lights Not Working It's easy to do. Caravan Tail Lights Not Working Flash10-12-2011, 01:38 PMI did find this in my manual.

Reply Cbourque says: June 21, 2016 at 6:29 pm We have found the problem, thank you, much appreciated Reply rwtrailerparts says: June 21, 2016 at 8:41 pm What was it? http://haiteq.com/not-working/caravan-ceiling-lights-not-working.php Whats the best mastic to use for resealing the roof skylight please. HeyYou View Public Profile Send a private message to HeyYou Find all posts by HeyYou #20 04-17-2012, 06:22 PM Purple97Ram Registered User Join Date: Apr 2012 Vehicle: 1997 http://www.2carpros.com/articles/turn-signals-not-working-blinker pupraiser10-12-2011, 02:15 PMToo busy for facts right now. Dodge Caravan Tail Light Not Working

A picture of the combination relay (if that's what is suspected) would be helpful, if anyone has one.The other electrical issues are as follows (maybe they're related, maybe not). I have found the interior lights do not work with the switch in it's central position with the caravan on 240v hookup. Hyper Nitro Core? http://haiteq.com/not-working/caravan-brake-lights-not-working.php Griz10-12-2011, 02:06 PMWife noticed the turn signal for passenger side was blinking rather quickly one day.

The common point is usually a small junction box at the front of the caravan or trailer. Any suggestions? It's easy to do.

Lighting Problem We have bought a 1980's Elddis caravan and have the following problem - All the inside plug sockets work but not the lights and we don't know why.

Once you have found it, replace it with a new one and see if that works.Has anyone out there got any suggestion to help? Please Help Me To Help My Husband We Installed These Led Licence Plate Screws. It's easy to do. Will keep you posted.

A list of breakers can be found on our website or you could try searching the internet to find one close to your location. Reply rwtrailerparts says: June 21, 2016 at 4:01 pm So, does it have a trailer wiring package, and is it the trailer tow package fuse that's blowing? Reply rwtrailerparts says: April 7, 2016 at 1:03 pm Are we talking about interior lights? this contact form So as your indicator flashes, it is also powering the side light on the caravan or trailer and the rear side light of the tow vehicle.

Anyways cleaning the wiring, etc did nothing to stop the shorts. You must be very careful when doing this as they can be quite brittle. I have Changed the bulb. Is there a specific relay for the running/tail lights?

If all functions are working, move on to the next step. Any ideas? I started basic checking and found that both left & right rear turn signals work, but the fronts are ok. One or both of the rear lights use a dual filament bulb, one filament for the tail light and the other for the brake/signal.

Simply click here to return to Caravan Questions and Answers. Why is translateY(-50%) needed to center an element which is at top: 50%? The wiring should be as follows:1 Yellow - left indicator2 Blue - Caravan fog light3 White - Earth4 Green - Right indicator5 Brown - Right hand tail light6 Red - Stop Reply Steve says: May 14, 2015 at 7:02 pm What do you recommend when I have tested the vehicle wiring and it's good?

Next day off we will rewire Reply Lance says: June 22, 2016 at 6:13 pm Excellent article. If you ask your local caravan dealer, they should be able to supply you with the correct bulbs etc. Those switches tend to pivot on their attachment bolt and loosen the ground wire if attached. I should try your nearest Fiat garage.

Password Register Forgot Password? You may have a loose connection. The term ground and earth are basically the same thing but the ‘earth' refers to the cable and the ground is the termination of the earth cable to the car in Any ideas please?

If you have replaced the bulb but it still blinks fast and the bulb does not illuminate properly the ground circuit inside the bulb socket has failed and replacement is required. I'll check out the harness when I can this week and post what I find.

>